- 1 Do you have to stagger plywood on a roof?
- 2 Can you use plywood on a roof?
- 3 How do you get heavy plywood on a roof?
- 4 How many sheets of plywood do you need for a roof?
- 5 Why do you stagger plywood?
- 6 What is the minimum thickness of roof sheathing?
- 7 Which plywood is best for roofing?
- 8 Can you put shingles directly on plywood?
- 9 Should I use OSB or plywood for roof?
- 10 Does roof sheathing go over fascia?
Do you have to stagger plywood on a roof?
Plywood panels should be laid with the face grain perpendicular to the rafter boards. The panels should be installed over two or more spans, with the long dimension or strength axis oriented across the rafter boards or truss cords. Staggering panels by at least two supports is recommended.
Can you use plywood on a roof?
Most roofs will be sheathed in plywood at least 3/8 inch thick. That will suffice on a roof with rafters set 16 inches apart with minimal roof loads. Loads will vary with the pitch of the roof; the flatter the roof, the greater the load on any one section. Steeper roofs will have lighter loads per square foot.
How do you get heavy plywood on a roof?
Take two 2x4s long enough to extend above the roof line by about 2′. Attach another section of 2×4 across them to hold them together at a height that will allow you to stack the plywood on it so that the top of the plywood sticks up above the top of the jack stand at the roof line.
How many sheets of plywood do you need for a roof?
Divide the total roof area by 32 to get the number of sheets you will need to cover the roof. A typical 4 foot by 8 foot sheet of plywood covers 32 square feet. If your roof area is 1,600 square feet, 1,600 divided by 32 will mean you need about 50 sheets to cover the roof.
Why do you stagger plywood?
The end joint is where one board or plywood sheet butts up against another. In almost every situation, it’s important to stagger these joints to avoid straight lines that extend in a perpendicular direction across the lengths of the boards. This is a matter of appearance, but more importantly, it’s one of stability.
What is the minimum thickness of roof sheathing?
Sheathing must be a minimum of 19/32-inch thick. Never affix roof sheathing with staples; 8d ring-shank nails need to be used instead. The normal thickness range for sheathing is 3/8 to 3/4 inch.
Which plywood is best for roofing?
CDX is the grade of plywood most commonly used for roofing (CDX plywood means it is Construction Grade for exterior purposes).
Can you put shingles directly on plywood?
A: It is never a good idea to install a roof over wet plywood or any type of roof sheathing. Trapped water will boil when the sun heats the roof and the shingles will then have small pits where the steam finally escapes.
Should I use OSB or plywood for roof?
OSB takes longer than plywood to get saturated, but also takes much longer to dry out. When used as roof sheathing, this tendency to hold moisture means it will degrade faster than plywood when exposed to chronic leaks.
Does roof sheathing go over fascia?
When sheathing a roof, the first step is to snap a line so that the first row goes on straight. But if you snap it at 40 inches, then the sheathing will not project over the subfascia or true fascia.