- 1 How many sheathing clips do I need?
- 2 Are plywood clips necessary?
- 3 Do you need plywood clips on 5/8 plywood?
- 4 How many plywood clips come in a box?
- 5 Are clips required for roof sheathing?
- 6 What is the purpose of H-clips?
- 7 Should I use OSB or plywood for roof?
- 8 Where do you put H clips?
- 9 What is the minimum thickness of roof sheathing?
- 10 What are hurricane clips?
- 11 Where do plywood clips go?
How many sheathing clips do I need?
When it comes to plywood sheathing for roofing purposes, the need for H-clips, also known as plywood clips or roof sheathing clips, may come up. How many do you need for each sheet of plywood? The answer is one clip for each rafter bay/cavity. This is a simple rule of thumb that applies to any roofing job.
Are plywood clips necessary?
Anyone installing 7/16″ OSB or plywood on 24 inch spans without end supports (clips) is in violation of “commonly accepted building standards” (the IRC) unless your jurisdiction has chosen to exclude that requirement by law.
Do you need plywood clips on 5/8 plywood?
According to the table in response #9, they’re only required for 5/8″ OSB with support spacing between 32″ and 40″. Obviously, adding them would make the sheathing stiffer than without them, at any span.
How many plywood clips come in a box?
Therefore you need 6 clips per one long egde and 12 clips per both long egdes. if the rafters are 24 inches O.C. and the plywood sheet is 8”, then you need 4 clips for 1 side and 8 for both sides. Longer plywood sheet could need more clips.
Are clips required for roof sheathing?
For the most common roof sheathing in our area, which is 1/2” nominal (7/16” actual) sheathing over trusses or rafters at 24” on center, there is no requirement for H-clips. One or two H-clips will often allow a longer span between roof trusses/rafters.
What is the purpose of H-clips?
H-clips, also called panel-edge clips, are small steel devices that fit snugly between wood panels in order to provide them with edge support. They are often used with roof sheathing to keep it from feeling spongy or soft at its edges.
Should I use OSB or plywood for roof?
OSB takes longer than plywood to get saturated, but also takes much longer to dry out. When used as roof sheathing, this tendency to hold moisture means it will degrade faster than plywood when exposed to chronic leaks.
Where do you put H clips?
Figure 1. Panel edge clip (H-clip) installation Top right: H-clip installed between adjacent roof sheathing panels and in between supporting trusses.
What is the minimum thickness of roof sheathing?
Sheathing must be a minimum of 19/32-inch thick. Never affix roof sheathing with staples; 8d ring-shank nails need to be used instead. The normal thickness range for sheathing is 3/8 to 3/4 inch.
What are hurricane clips?
What is a hurricane clip? Hurricane Ties, also known as rafter ties, truss ties, or hurricane clips, are used for deck or roof framing to secure rafters, trusses, or joists to the wood framework. This is done to resist uplift and lateral forces, like those that come from a hurricane or severe storm.
Where do plywood clips go?
The clips are inserted over the edges of the adjacent plywood panels to reduce deflection of the panel edges between the framing members and are most commonly used for roof sheathing. Plywood clips are inserted by hand and the procedure is done in conjunction with installation of the sheathing.